Date: 22 August 2007

Table of Contents

• Introduction
• Features of the Web Interface
  • Status
  • Log
  • Filter
  • Upgrade Monitoring Card Firmware
  • Clear Counters
  • Write Settings to Flash
  • Erase Settings from Flash
  • Set Admin Password
• Features of the TFT Color Display
  • face
  • log
  • big_uc
  • net
• Appendix: Common Maintenance Procedures
  1. How do I configure the monitoring line card (M3-MONITOR)?
  2. Can I assign a static IP address to the monitoring line card (M3-MONITOR)?
  3. How do I upgrade the firmware on the monitoring line card (M3-MONITOR)?
  4. How do we tell if the switch firmware is up-to-date?
  5. Can I store/save switch control settings on reboot?
  6. How do I cable the inter-switch connections in a 512-node configuration with the Clos256 Switches?
  7. Can you provide examples of how to use the SNMP interface to the Clos256 Switches?
  8. One of the connected switch ports is not illuminated in green/yellow.
  9. None of the connected switch ports on a switch line card are illuminated in green on the TFT display.
  10. The image on the TFT display is white/blank. How do I fix this?
  11. How should the cables between a M3-SPINE-ENCL/M3-SPINE-ENCL-B enclosure and M3-CLOS-ENCL/M3-CLOS-ENCL-B enclosures be connected?
  12. Why doesn't the mapper show the nodes across the M3-SPINE-ENCL/M3-SPINE-ENCL-B in my cluster?
  13. How do I cable a 768-node cluster?
  14. What are the guidelines for inter-switch cabling of a 1024-node cluster?
• Glossary: Switch Traps, Counters, and State Bits

Last updated: 22 August 2007